Jump to content

Switch - MissionControl 0.6.2


Retrohacked

Recommended Posts

GitHub Releases

This is the eleventh official release of Mission Control

This is mostly a bugfix release to address the rumble issues that have surfaced since recent Atmosphère releases. Support for the new N64 and Sega Genesis/Megadrive Nintendo Switch Online controllers has also been added. See below for the full changelog.

New users landing on this release page should first check out the readme on the main project page for the official project documentation. There you can find installation and usage instructions along with an FAQ section that will answer most of your questions.

Atmosphère >= 1.2.0 is required to run this release.

Important notice for users of Xbox One controllers

It has been confirmed that the new Xbox Insiders controller firmware update will convert your controller to use Bluetooth LE, which is not currently supported. Please do not update if you wish to continue using your controller with Mission Control

Changelog:

  • Added support for new N64 and Sega Genesis/Megadrive Nintendo Switch Online controllers
  • Fixed an issue where controllers would vibrate non-stop under certain conditions after connecting to the console
  • Fixed an issue where rumble output was missing from certain games
  • Fixed an issue where Crash Team Racing Nitro-Fueled and Crash Bandicoot N. Sane Trilogy games would output a constant stream of random rumble data
  • Disabled sending SetTsi command to Ouya controller (fixes disconnect issue)
  • Changed the order of initialisation commands for Sony controllers to reduce perceived delay when connecting to the console
  • Various improvements to the accuracy of controller subcommand handling were added

View the full article

Link to comment
Share on other sites

×
×
  • Create New...